Ipv6 Neighbor; Ipv6 Neighbors Dynamicrenew - NETGEAR M6100 Series Reference Manual

ipv6 neighbor

Configures a static IPv6 neighbor with the given IPv6 address and MAC address on a routing
or host interface.
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id
parameter is a number in the range of 1–4093.
Format
ipv6 neighbor ipv6address {unit/slot/port | vlan vland-id} macaddr
Mode Global Config
Parameter Definition
ipv6address The IPv6 address of the neighbor.
unit/slot/port The unit/slot/port for the interface.
vlan-id The VLAN for the interface.
macaddr The MAC address for the neighbor.
no ipv6 neighbor
Removes a static IPv6 neighbor with the given IPv6 address on a routing or host interface.
Format
no ipv6 neighbor ipv6address {unit/slot/port | vlan vland-id}
Mode Global Config

ipv6 neighbors dynamicrenew

Use this command to automatically renew the IPv6 neighbor entries. Enables/disables the
periodic NUD (neighbor unreachability detection) to be run on the existing IPv6 neighbor
entries based on the activity of the entries in the hardware. If the setting is disabled, only
those entries that are actively used in the hardware are triggered for NUD at the end of
STALE timeout of 1200 seconds. If the setting is enabled, periodically every 40 seconds a set
of 300 entries are triggered for NUD irrespective of their usage in the hardware.
Default
Disabled
Format
ipv6 neighbors dynamicrenew
Mode Global Config
M6100 Series Switches
IPv6 Commands
904