NETGEAR M6100 Series Reference Manual page 196

NETGEAR Managed Switch will not accept an incoming packet, such as a traceroute
response, that arrives on a routing interface if the packet's destination address is on one of
the out-of-band management interfaces (service port or network port). Similarly, NETGEAR
Managed Switch will not accept a packet that arrives on a management interface if the
packet's destination is an address on a routing interface. Thus, it would be futile to send a
traceroute on a management interface using a routing interface address as source, or to
send a traceroute on a routing interface using a management interface as source. When
sending a traceroute on a routing interface, the source must be that routing interface or
another routing interface. When sending a traceroute on a management interface, the source
must be on that management interface. For this reason, the user cannot specify the source
as a management interface or management interface address. When sending a traceroute
on a management interface, the user should not specify a source address, but instead let the
system select the source address from the outgoing interface.
Default count: 3 probes
interval: 3 seconds
size: 0 bytes
port: 33434
maxTtl: 30 hops
maxFail: 5 probes
initTtl: 1 hop
Format
traceroute {ip-address | [ipv6] {ipv6-address | hostname}} [initTtl initTtl]
[maxTtl maxTtl] [maxFail maxFail] [interval interval] [count count] [port
port] [size size] [source {ip-address | ipv6-address | unit/slot/port}]
Mode Privileged EXEC
Using the options described below, you can specify the initial and maximum time-to-live (TTL)
in probe packets, the maximum number of failures before termination, the number of probes
sent for each TTL, and the size of each probe.
Parameter Description
ipaddress The ipaddress value should be a valid IP address.
ipv6-address The ipv6-address value should be a valid IPv6 address.
hostname The hostname value should be a valid hostname.
ipv6 The optional ipv6 keyword can be used before ipv6-address or hostname. Giving the ipv6
keyword before the hostname tries it to resolve to an IPv6 address.
initTtl Use initTtl to specify the initial time-to-live (TTL), the maximum number of router hops
between the local and remote system. Range is 0 to 255.
maxTtl Use maxTtle to specify the maximum TTL. Range is 1 to 255.
maxFail Use maxFail to terminate the traceroute after failing to receive a response for this number of
consecutive probes. Range is 0 to 255.
M6100 Series Switches
Utility Commands
196