Show Ip Bgp Statistics - NETGEAR M6100 Series Reference Manual

Parameter Description
Cluster ID The cluster ID used by this router. The value configured with the
displayed. If no cluster ID is configured, the local router ID is shown and tagged as default.
Client-to-client Displays Enabled when this router reflects routes received from its clients to its other clients;
Reflection otherwise Disabled displays.
Clients A list of this router's internal peers that have been configured as route reflector clients.
Non-client Internal A list of this router's internal peers that are not configured as route reflector clients. Routes from
Peers non-client peers are reflected to clients and vice-versa.
Command example:
(NETGEAR Switch) #show ip bgp route-reflection
Cluster ID .................................... 1.1.1.1 (configured)
Client-to-client Reflection ................... Enabled
Clients: 172.20.1.2, 172.20.3.2, 172.20.5.2
Non-client Internal Peers: 192.168.1.2, 192.162.2.2
Skipping set statements in outbound route map gandolf when reflecting to internal peer
172.20.1.2.

show ip bgp statistics

This command displays recent decision process history. Phase 1 of the decision process
reacts to UPDATE messages received from peers, determining what new routes are
accepted and deleting withdrawn routes from the Adj-RIB-In. Phase 2 determines the best
path for each destination, updates the BGP route table, and updates the common RIB.
Phase 3 is run independently for each outbound update group and determines which routes
should be advertised to neighbors in each group. Each entry in the table shows statistics for
one phase of the decision process. The table shows the 20 most recent decision process
runs, with the most recent information at the end of the table.
Format
show ip bgp statistics
Mode Privileged EXEC
The command displays the following information.
Parameter Description
Delta T How long since the decision process was run. hours:minutes:seconds if the elapsed time is less than
24 hours. Otherwise, days:hours.
Phase Which phase of the decision process was run
Upd Grp Outbound update group ID. Only applies when phase 3 is run.
M6100 Series Switches
Border Gateway Protocol Commands
863
bgp cluster-id command is