Private Vlan Commands; Switchport Private-Vlan - NETGEAR M6100 Series Reference Manual

(NETGEAR Switch)#show dvlan-tunnel interface 1/0/1
Interface Mode
--------- ------- ------------
1/0/1 Disable 0x88a8

Private VLAN Commands

This section describes the commands you use for private VLANs. Private VLANs provides
Layer 2 isolation between ports that share the same broadcast domain. In other words, it
allows a VLAN broadcast domain to be partitioned into smaller point-to-multipoint
subdomains. The ports participating in a private VLAN can be located anywhere in the
Layer 2 network.

switchport private-vlan

This command defines a private-VLAN association for an isolated or community port or a
mapping for a promiscuous port.
Format
switchport private-vlan {host-association primary-vlan-id secondary-vlan-id
| mapping primary-vlan-id {add | remove} secondary-vlan-list}
Mode Interface Config
Parameter Description
host-association Defines the VLAN association for community or host ports.
mapping Defines the private VLAN mapping for promiscuous ports.
primary-vlan-id Primary VLAN ID of a private VLAN.
secondary-vlan-id Secondary (isolated or community) VLAN ID of a private VLAN.
add Associates the secondary VLAN with the primary one.
remove Deletes the secondary VLANs from the primary VLAN association.
secondary-vlan-list A list of secondary VLANs to be mapped to a primary VLAN.
no switchport private-vlan
This command removes the private-VLAN association or mapping from the port.
Format
no switchport private-vlan {host-association | mapping}
Mode Interface Config
M6100 Series Switches
EtherType
Switching Commands
379