Ipv6 Pim Bsr-Border; Ipv6 Pim Bsr-Candidate - NETGEAR M6100 Series Reference Manual

no ipv6 pim hello-interval
Use this command to set the PIM hello interval to the default value.
Format
no ipv6 pim hello-interval
Mode Interface Config

ipv6 pim bsr-border

Use this command to prevent bootstrap router (BSR) messages from being sent or received
on the specified interface.
Note: This command takes effect only when PIM-SM is enabled in the
Global mode.
Default disabled
Format
ipv6 pim bsr-border
Mode Interface Config
Command example:
(NETGEAR) (Interface 1/0/1) #ipv6 pim bsr-border
no ipv6 pim bsr-border
Use this command to disable the setting of BSR border on the specified interface.
Format
no ipv6 pim bsr-border
Mode Interface Config

ipv6 pim bsr-candidate

This command is used to configure the router to announce its candidacy as a bootstrap
router (BSR).
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter
is a number in the range of 1–4093.
Note: This command takes effect only when PIM-SM is configured as the
PIM mode.
M6100 Series Switches
IPv6 Multicast Commands
1117