NETGEAR M6100 Series Reference Manual page 680

unit/slot/port the same ensures that the correct interface configuration is applied to
each interface when the system restarts.
Format
vlan routing vlanid [interface-id]
Mode VLAN Config
no vlan routing
This command deletes routing on a VLAN.
Format
no vlan routing vlanid
Mode VLAN Config
Command example:
The following example specifies a VLAN ID value. The interface ID argument is not used.
(NETGEAR Switch)(Vlan)#vlan 14
(NETGEAR Switch)(Vlan)#vlan routing 14 ?
<cr>
<1-24>
Typically, you press Enter without supplying the Interface ID value; the system automatically
selects the interface ID.
Command example:
The following example specifies interface ID 51 for VLAN 14 interface. The interface ID
becomes the port number in the unit/slot/port for the VLAN routing interface. In this
example, unit/slot/port is 4/51 for VLAN 14 interface.
(NETGEAR Switch)(Vlan)#vlan 14 51
(NETGEAR Switch)(Vlan)#
(NETGEAR Switch)#show ip vlan
MAC Address used by Routing VLANs:
Logical
VLAN ID Interface
------- --------------
10 4/1
11 4/50
12 4/3
13 4/4
14 4/51
M6100 Series Switches
Press enter to execute the command.
Enter interface ID
00:11:88:59:47:36
IP Address Subnet Mask
------------- --------------
172.16.10.1 255.255.255.0
172.16.11.1 255.255.255.0
172.16.12.1 255.255.255.0
172.16.13.1 255.255.255.0
0.0.0.0 0.0.0.0 <--u/s/p is 4/51 for VLAN 14 interface
Routing Commands
680