Traffic-Class-Group Weight; Show Classofservice Traffic-Class-Group - NETGEAR M6100 Series Reference Manual

traffic-class-group weight

Use the traffic-class-group weight command in Global Config or Interface Config
mode to specify the weight for each interface TCG. The total number of TCGs supported per
interface is platform specific.
Default For TCG0:TCG1:TCG2, weights are in the ratio 100%:0%:0%
Format
traffic-class-group weight wp-0 wp-1 ... wp-n
Mode Global Config
Interface Config
The command specified in Interface Config mode only affects a single interface, whereas the
Global Config mode setting is applied to all interfaces. The Interface Config mode command
is only available on platforms that support independent per-port class-of-service queue
configuration.
Each wp-x (weight percentage) value is a percentage that ranges from 0 to 100 in increments
of 1. All n bandwidth values must be specified with this command, and their combined sum
must not exceed 100%. The number n is platform dependent and corresponds to the number
of supported Traffic Class Groups. The default weight percentage value is in the ratio of 1:2:3
for TCG0:TCG1:TCG2, which is calculated as 100%:0%:0%.
The weight percentage is not considered for TCG that are configured for strict scheduling.
no traffic-class-group weight
Use the no traffic-class-group weight command in Global Config or Interface
Config mode to restore the default for each queue's weight percentage value.
Format
no traffic-class-group weight wp-0 wp-1 ... wp-n
Mode Global Config
Interface Config

show classofservice traffic-class-group

Use the show classofservice traffic-class-group command in Privileged EXEC
mode to display the Traffic Class to Traffic Class Group mapping.
Format
show classofservice traffic-class-group [unit/slot/port]
Mode Privileged EXEC
M6100 Series Switches
Data Center Commands
596