Template Peer - NETGEAR M6100 Series Reference Manual

Parameter Description
ospf, connected, A source of routes to redistribute.
static
metric (Optional) When this option is specified, BGP advertises the prefix with the Multi Exit Discriminator
path attribute set to the configured value. If this option is not specified, but a default metric is
metric-value
configured for BGP
the MED is set to the default metric. If a default metric is not configured, then the prefix is
advertised without a MED attribute.
match (Optional) If you configure BGP to redistribute OSPF routes, BGP by default only redistributes
internal routes (OSPF intra-area and inter-area routes). Use the match option to configure BGP to
also redistribute specific types of external routes, or to disable redistribution of internal OSPF
routes.
route-map map-tag (Optional) A route map can be used to filter redistributed routes by destination prefix using a prefix
list. A route map can be used to set attributes on redistributed routes.
no redistribute (IPv6 Address Family Config)
This command removes the configuration for the redistribution for BGP protocol from the
specified source protocol or routers. For example, the command no redistribute opsf
match external 1 withdraws only OSPF external type 1 routes, OSPF internal routes are
still redistributed.
Format
no redistribute {ospf | connected | static} [metric metric-value]
[match {internal | external 1 | external 2 | nssa-external 1 |
nssa-external 2}] [route-map map-tag]
Mode IPv6 Address Family Config

template peer

To create a BGP peer template and enter Peer Template Configuration mode, use the
template peer command in Router Configuration mode. A peer template can be
configured with parameters that apply to many peers. Neighbors can then be configured to
inherit parameters from the peer template. A peer template can include both session
parameters and peer policies. Peer policies are configured with an address family
configuration mode and apply only to that address family. You can configure up to 32 peer
templates. When you make a change to a template, the change is immediately applied to all
neighbors that inherit from the template (although policy changes are subject to a
three-minute delay).
Note: NETGEAR Managed Switch does not support a remote-as
as-number command in Peer Template Configuration mode. The
neighbor's AS number must be specified when the neighbor is
created.
M6100 Series Switches
(default-information originate (IPv6 Address Family Config)
Border Gateway Protocol Commands
841
command), then