NETGEAR M6100 Series Reference Manual page 328

Hide thumbs Also See for M6100 Series:

Table of Contents

unit/slot/port

If not blank, this field indicates that this port is a special type of port. The possible values are:

Mirror — this port is a monitoring port. For more information, see

PC Mbr— this port is a member of a port-channel (LAG).

Probe — this port is a probe port.

The Port control administration state. The port must be enabled in order for it to be allowed into the

network. May be enabled or disabled. The factory default is enabled.

Admin Status

If the Admin Mode indicates that a port is disabled, this field states the reason why the port is

Physical Mode

The desired port speed and duplex mode. If auto-negotiation support is selected, then the duplex

mode and speed is set from the auto-negotiation process. Note that the maximum capability of the

port (full duplex -100M) is advertised. Otherwise, this object determines the port's duplex mode and

transmission rate. The factory default is Auto.

Physical Status

The port speed and duplex mode.

The Link is up or down.

This object determines whether or not to send a trap when link status changes. The factory default is

LACP is enabled or disabled on this port.

Command example:

The following example shows output for all ports:

(NETGEAR Switch) #show port all

--------- ------ --------- ---------- ---------- ------ ------- ------ --------

M6100 Series Switches

Switching Commands

Port Mirroring Commands

Chapters

Table of Contents