DHCPv6 Commands
This section describes the commands you use to configure the DHCPv6 server on the
system and to view DHCPv6 information.
service dhcpv6
This command enables DHCPv6 configuration on the router.
Default
enabled
Format
service dhcpv6
Mode
Global Config
no service dhcpv6
This command disables DHCPv6 configuration on router.
Format
no service dhcpv6
Mode
Global Config
ipv6 dhcp client pd
Use this command to enable the Dynamic Host Configuration Protocol (DHCP) for IPv6 client
process (if the process is not currently running) and to enable requests for prefix delegation
through a specified interface. When prefix delegation is enabled and a prefix is successfully
acquired, the prefix is stored in the IPv6 general prefix pool with an internal name defined by
the automatic argument.
Note:
The Prefix Delegation client is supported on only one IP interface.
rapid-commit enables the use of a two-message exchange method for prefix delegation
and other configuration. If enabled, the client includes the rapid commit option in a solicit
message.
The DHCP for IPv6 client, server, and relay functions are mutually exclusive on an interface.
If one of these functions is already enabled and a user tries to configure a different function
on the same interface, a message is displayed.
Default
Prefix delegation is disabled on an interface.
Format
ipv6 dhcp client pd [rapid-commit]
Mode
Interface Config
M6100 Series Switches
IPv6 Commands
971