Lacp Partner Admin State Individual; Lacp Partner Admin Key - NETGEAR M6100 Series Reference Manual

lacp partner admin key

Use this command to configure the administrative value of the Key for the protocol partner.
This command can be used to configure a single interface or a range of interfaces. The valid
range for key is 0 to 65535.
Default 0x0
Format
lacp partner admin key key
Mode Interface Config
Note: This command is applicable only to physical interfaces.
no lacp partner admin key
Use this command to set the administrative value of the key for the protocol partner to the
default.
Format
no lacp partner admin key
Mode Interface Config

lacp partner admin state individual

Use this command to set LACP partner admin state to individual.
Format
lacp partner admin state individual
Mode Interface Config
Note: This command is applicable only to physical interfaces.
no lacp partner admin state individual
Use this command to set the LACP partner admin state to aggregation.
Format
no lacp partner admin state individual
Mode Interface Config
M6100 Series Switches
Switching Commands
449