NETGEAR M6100 Series Reference Manual page 223

netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
• h-node—Hybrid (recommended)
Default none
Format
netbios-node-type type
Mode DHCP Pool Config
no netbios-node-type
This command removes the NetBIOS node Type.
Format
no netbios-node-type
Mode DHCP Pool Config
next-server
This command configures the next server in the boot process of a DHCP client.The address
parameter is the IP address of the next server in the boot process, which is typically a TFTP
server.
Default inbound interface helper addresses
Format
next-server address
Mode DHCP Pool Config
no next-server
This command removes the boot server list.
Format
no next-server
Mode DHCP Pool Config
option
The command configures DHCP Server options. The code parameter specifies the
option
DHCP option code and ranges from 1-254. The ascii string parameter specifies an NVT
ASCII character string. ASCII character strings that contain white space must be delimited by
quotation marks. The hex string parameter specifies hexadecimal data. In hexadecimal,
character strings are two hexadecimal digits. You can separate each byte by a period (for
M6100 Series Switches
Utility Commands
223