Virtual Router Redundancy Protocol Commands; Show Ip Vlan; Ip Vrrp (Global Config) - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches

show ip vlan

This command displays the VLAN routing information for all VLANs with routing enabled.
Format
show ip vlan
Modes • Privileged EXEC
• User EXEC
Term Definition
MAC Address The MAC Address associated with the internal bridge-router interface (IBRI). The same MAC
used by Routing Address is used by all VLAN routing interfaces. It will be displayed above the per-VLAN
VLANs information.
VLAN ID The identifier of the VLAN.
Logical Interface The logical slot/port associated with the VLAN routing interface.
IP Address The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.

Virtual Router Redundancy Protocol Commands

This section describes the commands you use to view and configure Virtual Router Redundancy
Protocol (VRRP) and to view VRRP status information. VRRP helps provide failover and load
balancing when you configure two devices as a VRRP pair.

ip vrrp (Global Config)

Use this command in Global Config mode to enable the administrative mode of VRRP on the
router.
Default none
Format
ip vrrp
Mode Global Config
no ip vrrp
Use this command in Global Config mode to disable the default administrative mode of VRRP on
the router.
Format
no ip vrrp
Mode Global Config
Routing Commands
199