NETGEAR M6100 Series Reference Manual page 1066

Session aging time: 10 min
Maximum number of sessions is 192
--------------------------------------------
iSCSI Targets and TCP ports:
--------------------------------------------
TCP Port Target IP Address
860 Not Configured
3260 Not Configured
Command example:
The following example enable iSCSI:
(NETGEAR Switch)#configure
(NETGEAR Switch)(config)#iscsi enable
Command example:
The following examples shows that iSCSI sessions and connections are established using
TCP ports 3260 or 860. Packets sent on detected iSCSI TCP connections are assigned to
traffic class 2 (see the CoS configuration shown below). Because remark is enabled, the
packets are marked with IEEE 802.1p priority to 5 before transmission.
(NETGEAR Switch)#show iscsi
iscsi enabled
iSCSI vpt is 5, remark
Session aging time: 10 min
Maximum number of sessions is 192
--------------------------------------------
iSCSI Targets and TCP ports:
--------------------------------------------
TCP Port Target IP Address
860 Configured
3260 Configured
(NETGEAR Switch)#show classofservice dot1p-mapping
User Priority Traffic Class
------------- -------------
0
1
2
3
4
5
6
6
M6100 Series Switches
Name
Not Configured
Not Configured
Name
Not Configured
Not Configured
1
0
0
1
2
2
3
3
Quality of Service Commands
1066