Timers Throttle Spf; Trapflags (Ospfv) - NETGEAR M6100 Series Reference Manual

timers throttle spf

The initial wait interval is set to an amount of delay specified by the spf-hold value. If an
SPF calculation is not scheduled during the current wait interval, the next SPF calculation is
scheduled at a delay of spf-start. If there has been an SPF calculation scheduled during
the current wait interval, the wait interval is set to two times the current wait interval until the
wait interval reaches the maximum time in milliseconds as specified in spf-maximum.
Subsequent wait times remain at the maximum until the values are reset or an LSA is
received between SPF calculations.
Default spf-start = 2000 ms
spf-hold = 5000 ms
spf-maximum = 5000 ms
Format
timers throttle spf spf-start spf-hold spf-maximum
Mode Router OSPFv3 Config
Parameter Description
spf-start Indicates the SPF schedule delay in milliseconds when no SPF calculation has been scheduled
during the current wait interval. Value range is 1 to 600000 milliseconds.
spf-hold Indicates the initial SPF wait interval in milliseconds. Value range is 1 to 600000 milliseconds.
spf-maximum Indicates the maximum SPF wait interval in milliseconds. Value range is 1 to 600000 milliseconds.
no timers throttle spf
This command returns the SPF throttling parameters to the factory default values.
Format
no timers throttle spf
Mode Router OSPFv3 Config
trapflags (OSPFv3)
Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or
enable all the trap flags at a time. The different groups of trapflags, and each group's specific
trapflags to enable or disable, are listed in the following table.
M6100 Series Switches
IPv6 Commands
942