Sflow Source-Interface - NETGEAR M6100 Series Reference Manual

To overcome this situation, sFlow polling interval configuration on an interface or range of
interfaces is controlled as mentioned below:
1. The maximum number of allowed interfaces for the polling intervals max (1, (interval –
10)) to min ((interval + 10), 86400) is:
interval * 5
2. For every one second increment in the polling interval that is configured, the number of
allowed interfaces that can be configured increases by 5.
no sflow poller
Use this command to reset the sFlow poller instance to the default settings.
Format
no sflow poller [interval]
Mode Interface Config

sflow source-interface

Use this command to specify the physical or logical interface to use as the sFlow client
source interface. If configured, the address of source Interface is used for all sFlow
communications between the sFlow receiver and the sFlow client. Otherwise there is no
change in behavior. If the configured interface is down, the sFlow client falls back to normal
behavior.
Format
sflow source-interface {unit/slot/port | loopback loopback-id | tunnel
tunnel-id | vlan vlan-id}
Mode Global Config
Parameter Description
unit/slot/port VLAN or port-based routing interface.
loopback-id Configures the loopback interface to use as the source IP address. The range of the loopback ID is
0 to 7.
tunnel-id Configures the tunnel interface to use as the source IP address. The range of the tunnel ID is 0 to 7.
vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to
4093.
no sflow source-interface
Use this command to reset the sFlow source interface to the default settings.
Format
no sflow source-interface
Mode Global Config
M6100 Series Switches
Utility Commands
282