NETGEAR M6100 Series Reference Manual page 1177

Table 68. PIM-DM Log Messages (continued)
Component Message
PIMDM Mcast Forwarding Mode Disable Failed for intf –
xxx.
PIMDM Mcast Forwarding Mode Enable Failed for intf –
xxx.
PIMDM PIMDMv6 Socket Memb'ship Enable Failed for
rtrIfNum - xxx.
PIMDM PIMDMv6 Socket Memb'ship Disable Failed for
rtrIfNum – xxx.
PIMDM PIMDM FSM Action Invoke Failed; rtrIfNum - xxx
Out of Bounds for Event – xxx.
PIMDM PIMDM Socket Initialization Failed for addrFamily
- xxx.
PIMDM PIMDMv6 Socket Memb'ship Enable Failed for
rtrIfNum - xxx.
PIMDM PIMDMv6 Socket Memb'ship Disable Failed for
rtrIfNum – xxx.
PIMDM PIMDM MRT Table Max Limit - xxx Reached;
Cannot accommodate any further routes.
Table 69. DVMRP Log Messages
Component Message
DVMRP DVMRP Heap memory initialization is Failed for
the specified address family.
DVMRP DVMRP Heap memory de-initialization is Failed
for the specified address family.
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1177
Cause
Multicast Forwarding Mode Disable Failed. As a
result of this, Multicast packets are still received at
the application though no protocol is enabled.
Multicast Forwarding Mode Enable Failed. As a result
of this, Multicast packets will not be received at the
application though a protocol is enabled.
PIMDMv6 Socket Creation/options Set with Kernel IP
Stack Failed. As a result of this, the PIM Control
packets cannot be received on the interface.
PIMDMv6 Socket Creation/options Disable with
Kernel IP Stack Failed. As a result of this, the PIM
Control packets are still received on the interface at
the application though no protocol is enabled.
The PIMDM FSM Action invocation Failed due to
invalid Routing interface number. In such cases, the
FSM Action routine can never be invoked which may
result in abnormal behavior. The failed FSM-name
can be identified from the specified Event name.
PIMDM Socket Creation/options Set Failed. As a
result of this, the PIM Control packets cannot be sent
out on an interface.
Socket options Set to enable the reception of PIMv6
packets Failed. As a result of this, the PIMv6 packets
will not be received by the application.
PIMDMv6 Socket Creation/options Disable with
Kernel IP Stack Failed. As a result of this, the PIMv6
Control packets are still received on the interface at
the application though no protocol is enabled.
PIMDM Multicast Route table (S,G) has reached
maximum capacity and cannot accommodate new
registrations anymore.
Cause
This message appears when trying to enable
DVMRP Protocol
This message appears when trying to disable
DVMRP Protocol. As a result of this, the subsequent
attempts to enable/disable DVMRP will also fail.