NETGEAR M6100 Series Reference Manual page 918

Term Definition
Route-Timestamp The last updated time for dynamic routes. The format of Route-Timestamp is:
Days:Hours:Minutes if days > = 1
Hours:Minutes:Seconds if days < 1
Interface The outgoing router interface to use when forwarding traffic to the next destination. For reject routes,
the next hop interface would be Null0 interface.
T A flag appended to an IPv6 route to indicate that it is an ECMP route, but only one of its next hops
has been installed in the forwarding table. The forwarding table may limit the number of ECMP
routes or the number of ECMP groups. When an ECMP route cannot be installed because such a
limit is reached, the route is installed with a single next hop. Such truncated routes are identified by
a T after the interface name.
To administratively control the traffic destined to a particular network and prevent it from
being forwarded through the router, you can configure a static reject route on the router. Such
traffic would be discarded and the ICMP destination unreachable message is sent back to the
source. This is typically used for preventing routing loops. The reject route added in the RTO
is of the type OSPF Inter-Area. Reject routes (routes of REJECT type installed by any
protocol) are not redistributed by OSPF/RIP. Reject routes are supported in both OSPFv2
and OSPFv3.
Command example:
(NETGEAR Routing) #show ipv6 route
IPv6 Routing Table - 3 entries
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
S 2001::/64 [10/0] directly connected,
C 2003::/64 [0/0]
via ::, 0/11
S 2005::/64 [1/0]
via 2003::2,
C 5001::/64 [0/0]
via ::, 0/5
OE1 6001::/64 [110/1]
via fe80::200:42ff:fe7d:2f19,
OI 7000::/64 [110/6]
via fe80::200:4fff:fe35:c8bb,
M6100 Series Switches
0/11
00h:00m:23s,
00h:01m:47s,
IPv6 Commands
918
Null0
0/5
0/11