Show Ip Pim Interface - NETGEAR M6100 Series Reference Manual

Command example:
If no SSM group range is configured, the command displays the following message:
No SSM address range is configured.

show ip pim interface

This command displays the PIM interface status parameters.
The argument unit/slot/port corresponds to a physical routing interface or VLAN
routing interface. The vlan keyword and vland-id parameter are used to specify the VLAN
ID of the routing VLAN directly instead of in the unit/slot/port format. The vlan-id parameter
is a number in the range of 1–4093.
If no interface is specified, the command displays the status parameters of all PIM-enabled
interfaces.
Format
show ip pim interface [unit/slot/port | vlan vlan-id]
Modes Privileged EXEC
User EXEC
Term Definition
Interface unit/slot/port, which is the interface number.
Mode Indicates the active PIM mode enabled on the interface is dense or sparse.
Hello Interval The frequency at which PIM hello messages are transmitted on this interface. By default, the value is
30 seconds.
Join Prune Interval The join/prune interval value for the PIM router. The interval is in seconds.
DR Priority The priority of the Designated Router configured on the interface. This field is not applicable if the
interface mode is Dense.
BSR Border Identifies whether this interface is configured as a bootstrap router border interface.
Neighbor Count The number of PIM neighbors learned on this interface. This is a dynamic value and is shown only
when a PIM interface is operational.
Designated Router The IP address of the elected Designated Router for this interface. This is a dynamic value and will
only be shown when a PIM interface is operational. This field is not applicable if the interface mode
is Dense.
Command example:
(NETGEAR) #show ip pim interface
Interface.........................................1/0/1
Mode............................................Sparse
Hello Interval (secs)...........................30
Join Prune Interval (secs)......................60
DR Priority.....................................1
M6100 Series Switches
IP Multicast Commands
1091