Clear Ip Mroute; Dvmrp Commands; Ip Dvmrp (Global Config) - NETGEAR M6100 Series Reference Manual

Hide thumbs Also See for M6100 Series:

Table of Contents

clear ip mroute

This command deletes all or the specified IP multicast route entries.This command clears

only dynamic mroute entries. It does not clear static mroutes.

clear ip mroute {* | group-address [source-address]}

Privileged EXEC

Deletes all IPv4 entries from the IP multicast routing table.

group-address

IP address of the multicast group.

source-address

The optional IP address of a multicast source that is sending multicast traffic to the group.

Command example:

The following example deletes all entries from the IP multicast routing table:

(NETGEAR Routing) # clear ip mroute *

Command example:

The following example deletes all entries from the IP multicast routing table that match the

multicast group address (224.1.2.1), irrespective of which source is sending for this group:

(NETGEAR Routing) # clear ip mroute 224.1.2.1

Command example:

The following example deletes all entries from the IP multicast routing table that match the

multicast group address (224.1.2.1) and the multicast source address (192.168.10.10):

(NETGEAR Routing) # clear ip mroute 224.1.2.1 192.168.10.10

This section describes the Distance Vector Multicast Routing Protocol (DVMRP) commands.

This command sets administrative mode of DVMRP in the router to active.

Global Config

M6100 Series Switches

IP Multicast Commands

Table of Contents