Show Ip Bgp Summary - NETGEAR M6100 Series Reference Manual

Parameter Description
GenId Generation ID of BGP routing table when decision process was run. The generation ID is
incremented each time phase 2 of the decision process is run and when there is a change to the
status of aggregate addresses.
Reason The event that triggered the decision process to run
Peer Phase 1 of the decision process can be triggered for a specific peer when a peer's inbound routing
policy changes or the peer is reset. When phase 1 is run for a single peer, the peer's IP address is
given.
Duration How long the decision process took, in milliseconds
Adds The number of routes added. For phase 1, this is the number of prefixes that pass inbound policy
and are added to the Accept-RIB-In. For phase 2, this is the number of routes added to the BGP
routing table. For phase 3, this is the number of prefixes added to the update group's Adj-RIB-Out.
Mods The number of routes modified. Always 0 for phase 1.
Dels The number of routes deleted. Always 0 for phase 1.
Command example:
(R1) # show ip bgp statistics
Delta T Phase Upd Grp
29:33:49 3
29:33:40 2
29:33:28 2
29:23:40 2
29:13:40 3
29:02:40 1
29:02:01 3
28:33:40 2
28:15:00 1
28:14:40 2

show ip bgp summary

This command displays a summary of BGP configuration and status.
Format
show ip bgp summary
Mode Privileged EXEC
M6100 Series Switches
GenId Reason
0 2041 Fwd status chng
2042 Accept-RIB-In-
2043 Accept-RIB-In-
2044 Accept-RIB-In-
1 2044 Phase 2 done
2044 Adj-RIB-In+
0 2044 Phase 2 done
2045 Phase 1 done
2045 Adj-RIB-In+
2046 Phase 1 done
Border Gateway Protocol Commands
864
Peer Duration Adds
34 750
59 750
10
32
48 500
0.0.0.0 21 500
41 750
32 500
0.0.0.0 9 250
16
Mods Dels
0 500
0 500
0 0 250
0 0 1000
2500 1750
0 0
0 1250
0
0 0
250 0