NETGEAR M6100 Series Reference Manual page 294

1/0/6 Enabled
1/0/7 Enabled
--More-- or (q)uit
If you specify the port, the command displays the information in the following table.
Term
Energy Detect
Energy-detect admin mode
Energy-detect operational status
Reason for Energy-detect current
operational status
EEE
EEE Admin Mode
Transmit Idle Time
Transmit Wake Time
Rx Low Power Idle Event Count
Rx Low Power Idle Duration (Sec) This field indicates duration of Rx LPI state in 10 s increments. Shows the
Tx Low Power Idle Event Count
Rx Low Power Idle Duration (Sec) This field indicates duration of Tx LPI state in 10 s increments. Shows the
Tw_sys_tx (Sec)
Tw_sys Echo (Sec)
M6100 Series Switches
Active Enabled
Active Enabled
Definition
Energy-detect mode is enabled or disabled
Energy detect mode is currently active or inactive. The energy-detect
mode may be administratively enabled, but the operational status may be
inactive. The possible reasons for the status are described below.
The energy detect mode may be administratively enabled, but the
operational status may be inactive for one of the following reasons:
• Port is currently operating in the fiber mode
• Link is up.
• Admin Mode Disabled
If the energy-detect operational status is active, this field displays No
energy detected.
EEE Admin Mode is enabled or disabled.
It is the time for which condition to move to LPI state is satisfied, at the end
of which MAC TX transitions to LPI state. The Range is (0 to 429496729).
The Default value is 0
It is the time for which MAC / switch has to wait to go back to ACTIVE state
from LPI state when it receives packet for transmission. The Range is (0 to
65535).The Default value is 0.
This field is incremented each time MAC RX enters LP IDLE state. Shows
the total number of Rx LPI Events since EEE counters are last cleared.
total duration of Rx LPI since the EEE counters are last cleared.
This field is incremented each time MAC TX enters LP IDLE state. Shows
the total number of Tx LPI Events since EEE counters are last cleared.
total duration of Tx LPI since the EEE counters are last cleared.
Integer that indicates the value of Tw_sys that the local system can
support. This value is updated by the EEE DLL Transmitter state diagram.
Integer that indicates the remote system's Transmit Tw_sys that was used
by the local system to compute the Tw_sys that it wants to request from
the remote system.
Utility Commands
294
Disabled Inactive
Disabled Inactive
Enabled
Enabled