Auto-Voip Vlan; Show Auto-Voip - NETGEAR M6100 Series Reference Manual

no auto-voip protocol-based
Use this command to reset the global protocol based auto VoIP remarking priority or
traffic-class to the default.
Format
no auto-voip protocol-based {remark remark-priority | traffic-class tc}
Mode Global Config
Interface Config

auto-voip vlan

Use this command to configure the global Auto VoIP VLAN ID. The VLAN behavior is depend
on the configured auto VoIP mode. The auto-VoIP VLAN is the VLAN used to segregate VoIP
traffic from other non-voice traffic. All VoIP traffic that matches a value in the known OUI list
gets assigned to this VoIP VLAN.
Default None
Format
auto-voip vlan vlan-id
Mode Global Config
no auto-voip vlan
Use the no form of the command to reset the auto-VoIP VLAN ID to the default value.
Format
no auto-voip vlan
Mode Global Config

show auto-voip

Use this command to display the auto VoIP settings on one particular interface or on all
interfaces of the switch.
Format
show auto-voip {protocol-based | oui-based} interface {unit/slot/port | all}
Mode Privileged EXEC
Field Description
VoIP VLAN ID The global VoIP VLAN ID.
Prioritization Type The type of prioritization used on voice traffic.
Class Value • If the Prioritization Type is configured as traffic-class, then this value is the queue value.
• If the Prioritization Type is configured as remark, then this value is 802.1p priority used to
remark the voice traffic.
M6100 Series Switches
Quality of Service Commands
1060