Auto-Voice Over Ip Commands - NETGEAR M6100 Series Reference Manual

Hide thumbs Also See for M6100 Series:

Table of Contents

The information in the following table displays when no time range name is specified.

Current number of all Time

Maximum number of all Time

Time Range Name

Periodic Entry count

Absolute Entry

Auto-Voice over IP Commands

This section describes the commands you use to configure Auto-Voice over IP (VoIP)

commands. The Auto-VoIP feature explicitly matches VoIP streams in Ethernet switches and

provides them with a better class-of-service than ordinary traffic. When you enable the

Auto-VoIP feature on an interface, the interface scans incoming traffic for the following

call-control protocols:

Session Initiation Protocol (SIP)

Skinny Client Control Protocol (SCCP)

When a call-control protocol is detected, the switch assigns the traffic in that session to the

highest CoS queue, which is generally used for time-sensitive traffic.

Use this command to configure auto VoIP mode. The supported modes are protocol-based

and oui-based. Protocol-based auto VoIP prioritizes the voice data based on the layer 4 port

used for the voice session. OUI based auto VoIP prioritizes the phone traffic based on the

known OUI of the phone.

When both modes are enabled, if the connected phone OUI is one of the configured OUI,

then the voice data is prioritized using OUI Auto VoIP, otherwise protocol-based Auto VoIP is

used to prioritize the voice data.

M6100 Series Switches

The administrative mode of the time range feature on the switch

The number of time ranges currently configured in the system.

The maximum number of time ranges that can be configured in the system.

Name of the time range.

Status of the time range (active/inactive)

The number of periodic entries configured for the time range.

Indicates whether an absolute entry has been configured for the time range (Exists).

Quality of Service Commands

Table of Contents