NETGEAR M6100 Series Reference Manual page 1155

Table 21. SIM Log Message
Component Message
SIM IP address conflict on service port/network port
for IP address x.x.x.x. Conflicting host MAC
address is xx:xx:xx:xx:xx:xx
Table 22. System Log Messages
Component Message
SYSTEM The size of the startup-config.cfg
configuration file is 0 (zero) bytes
SYSTEM could not separate
SYSAPI_CONFIG_FILENAME
SYSTEM Building defaults for file file name version version
num
SYSTEM File filename: same version (version num) but the
sizes (version size – expected version size) differ
SYSTEM Migrating config file filename from version
version num to version num
SYSTEM Building Defaults
SYSTEM sysapiCfgFileGet failed size = expected size of
file version = expected version
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1155
Cause
This message appears when an address conflict
is detected in the LAN for the service
port/network port IP.
Cause
The configuration file could not be read. This
message may occur on a system for which no
configuration has ever been saved or for which
configuration has been erased.
The configuration file could not be read. This
message may occur on a system for which no
configuration has ever been saved or for which
configuration has been erased.
Configuration did not exist or could not be read
for the specified feature or file. Default
configuration values will be used. The file name
and version are indicated.
The configuration file which was loaded was of a
different size than expected for the version
number. This message indicates the
configuration file needed to be migrated to the
version number appropriate for the code image.
This message may appear after upgrading the
code image to a more current release.
The configuration file identified was migrated
from a previous version number. Both the old and
new version number are specified. This message
may appear after upgrading the code image to a
more current release.
Configuration did not exist or could not be read
for the specified feature. Default configuration
values will be used.
Configuration did not exist or could not be read
for the specified feature. This message is usually
followed by a message indicating that default
configuration values will be used.