NETGEAR M6100 Series Reference Manual page 642

Parameter Description
Distance The administrative distance for RIP routes.
Redistribution A table showing information for each source protocol (connected, static, bgp, and ospf). For each of
these source the distribution list and metric are shown. Fields which are not configured are left blank.
For ospf, configured ospf match parameters are also shown.
Interface The interfaces where RIP is enabled and the version sent and accepted on each interface.
Command example:
(NETGEAR Switch) #show ip protocols
Routing Protocol.......................... BGP
Router ID................................. 6.6.6.6
Local AS Number........................... 65001
BGP Admin Mode............................ Enable
Maximum Paths............................. Internal 32, External 32
Always compare MED ....................... FALSE
Maximum AS Path Length ................... 75
Fast Internal Failover ........................ Enable
Fast External Failover ........................ Enable
Distance.................................. Ext 20 Int 200 Local 200
Address Wildcard
------- --------
172.20.0.0 0.0.255.255
172.21.0.0 0.0.255.255
Prefix List In............................ PfxList1
Prefix List Out........................... None
Redistributing:
Source Metric
--------- ----------
connected
static 32120
rip 30000
ospf
ospf match: int ext1 nssa-ext2
Networks Originated:
10.1.1.0 255.255.255.0 (active)
20.1.1.0 255.255.255.0
Neighbors:
172.20.1.100
M6100 Series Switches
Distance
--------
40
45
Dist List
----------------------- ---------------------------
connected_list
Routing Commands
642
Pfx List
--------
None
1
Route Map
static_routemap
rip_routemap
ospf_map