match length
Use this command to configure a route map to match based on the Layer 3 packet length
between specified minimum and maximum values. min specifies the packet's minimum
Layer 3 length, inclusive, allowed for a match. max specifies the packet's maximum Layer 3
length, inclusive, allowed for a match. Each route-map statement can contain one 'match'
statement on packet length range.
Default
No match criteria are defined by default.
Format
match length min max
Mode
Route Map Configuration
Command example:
(NETGEAR Switch) (config-route-map)# match length 64 1500
no match length
Use this command to delete a match statement from a route map.
Format
no match length
Mode
Route Map Configuration
match mac-list
Use this command to configure a route map in order to match based on the match criteria
configured in an MAC access-list.
A MAC ACL is configured before it is linked to a route-map. Actions present in MAC ACL
configuration are applied with other actions involved in route-map. When a MAC ACL
referenced by a route-map is removed, the route-map rule is also removed and the
corresponding rule is not effective. When a MAC ACL referenced by a route-map is removed
or rules are added or deleted from that ACL, the configuration is rejected.
Default
No match criteria are defined by default.
Format
match mac-list mac-list-name [mac-list-name]
Mode
Route Map Configuration
Parameter
Description
mac-list-name
The mac-list name that identifies MAC ACLs. MAC access list name can be up to 31 characters
in length.
M6100 Series Switches
Routing Commands
663