Chapter 11 Border Gateway Protocol Commands; Bgp Commands; Router Bgp; Address-Family Ipv - NETGEAR M6100 Series Reference Manual

BGP Commands

router bgp

This command enables BGP and identifies the autonomous system (AS) number of the
router. Only a single instance of BGP can be run and the router can only belong to a single
AS.
Default BGP is inactive by default.
Format
router bgp as-number
Mode Global Config
Parameter Description
as-number The router's autonomous system number (ASN).
no router bgp
If you enter the no router bgp command, BGP is disabled and all BGP configuration
reverts to default values. Alternatively, you can use
Router Configuration mode to disable BGP globally without clearing the BGP configuration.
Default BGP is inactive by default.
Format
no router bgp as-number
Mode Global Config

address-family ipv6

To enter IPv6 Address Family Configuration mode in order to specify IPv6-specific
configuration parameters, use the address-family ipv6 command in BGP Router
Configuration mode. Commands entered in this mode can be used to enable exchange of
IPv6 routes, specify IPv6 prefixes to be originated, and configure inbound and outbound
policies to be applied to IPv6 routes.
Default Exchange of IPv6 routes is disabled by default.
Format
address-family ipv6
Mode BGP Router Config
M6100 Series Switches
Border Gateway Protocol Commands
799
no enable (BGP) on page 815 in BGP