NETGEAR M6100 Series Reference Manual page 607

The command output format is different when the detail option is used. The information
below is displayed.
Parameter Description
VLAN VLAN to which the session belongs.
FC-MAP FCMAP value used by the FCF.
FCFs Number of FCFs discovered.
ENodes Number of ENodes discovered.
Sessions Total virtual sessions in FCoE VLAN.
FCF Information
Interface Interface on which the FCF is discovered.
MAC MAC address of the FCF.
ENodes Total number of ENodes that are connected to the FCF.
Sessions Total number of virtual sessions accepted by FCF in the associated VLAN.
ENode Information
Interface Interface to which the ENode is connected.
MAC MAC address of the ENode.
Sessions Total number of virtual sessions originated from ENodes to FCF in the VLAN.
Waiting Total number of virtual connections waiting for FCF acceptance in the VLAN.
Session Information
FCoE-MAC Source MAC address of the FCoE packets that are originated by the ENode as part of the session.
Request (FP, SP) FIP session request type sent by ENode. This can be FLOGI or FDESC (NPIV FDISC). Whereas FP
and SP values are the FP bit and the SP bit values in the FLOGI or NPIV FDISC request
respectively.
Expiry Time This is virtual connection/session expiry interval. This is used to monitor the status of the session.
Session entry is removed when the value reaches 0. This value is reset to 450 secs (5*90 secs)
every time an associated VN_Port FKA is received from the ENode. This is ignored (marked as NA)
if the D-bit is set to one in the FCF Discovery Advertisements.
Mode This is the addressing mode in use by the VN_Port at ENode. In other words, this is the type of MAC
address granted (selected and returned) by FCF. This can be one of the addressing modes, i.e.
FPMA or SPMA.
State This is the state of the virtual session. The state is displayed as Tentative during the process of
ENode login to FCF (using FLOGI or FDESC). It displays Active after ENode and FCF establish a
successful virtual connection.
Session-Time Time elapsed after this successful virtual session is established by ENode with FCF. The value is
displayed in xd, yh, zm format where x represents number of days, y represents hours and z
represents minutes elapsed following this successful virtual session. This field has no useful
information for waiting sessions.
M6100 Series Switches
Data Center Commands
607