NETGEAR M6100 Series Reference Manual page 1169

Table 51. 802.1Q Log Messages (continued)
Component Message
802.1Q Failed to delete, Default VLAN %d cannot be
deleted
802.1Q Failed to delete, VLAN ID %d is not a static VLAN
802.1Q Requestor %d attempted to release internal VLAN
%d: owned by %d
Table 52. 802.1S Log Messages
Component Message
802.1S dot1sIssueCmd: Dot1s Msg Queue is
full!!!!Event: %u, on interface: %u, for instance:
%u
802.1S dot1sStateMachineRxBpdu(): Rcvd BPDU
Discarded
802.1S dot1sBpduTransmit(): could not get a buffer
Table 53. Port Mac Locking Log Message
Component Message
Port Mac Locking pmlMapIntfIsConfigurable: Error accessing PML
config data for interface %d in
pmlMapIntfIsConfigurable.
Table 54. Protocol-based VLANs Log Messages
Component Message
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to
VLANs register NIM callback
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to
VLANs register pbVlan callback with VLANs
Protocol Based pbVlanCnfgrInitPhase2Process: Unable to
VLANs register pbVlan callback with nvStore
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1169
Cause
Trying to delete Default VLAN ID.
Trying to delete Dynamic VLAN ID from CLI.
-
Cause
The message Queue is full.
The current conditions, like port is not enabled or
we are currently not finished processing another
BPDU on the same interface, does not allow us
to process this BPDU.
Out of system buffers.
Cause
A default configuration does not exist for this
interface. Typically a case when a new interface
is created and has no preconfiguration.
Cause
Appears when nimRegisterIntfChange fails to
register pbVlan for link state changes.
Appears when VLANRegisterForChange fails to
register pbVlan for VLAN changes.
Appears when nvStoreRegister fails to register
save and restore functions for configuration save.