Dhcpv6 Snooping Configuration Commands; Ipv6 Dhcp Snooping; Ipv6 Dhcp Snooping Vlan; Ipv6 Dhcp Snooping Verify Mac-Address - NETGEAR M6100 Series Reference Manual

DHCPv6 Snooping Configuration Commands

This section describes commands you use to configure IPv6 DHCP Snooping.

ipv6 dhcp snooping

Use this command to globally enable IPv6 DHCP Snooping.
Default disabled
Format
ipv6 dhcp snooping
Mode Global Config
no ipv6 dhcp snooping
Use this command to globally disable IPv6 DHCP Snooping.
Format
no ipv6 dhcp snooping
Mode Global Config

ipv6 dhcp snooping vlan

Use this command to enable DHCP Snooping on a list of comma-separated VLAN ranges.
Default disabled
Format
ipv6 dhcp snooping vlan vlan-list
Mode Global Config
no ipv6 dhcp snooping vlan
Use this command to disable DHCP Snooping on VLANs.
Format
no ipv6 dhcp snooping vlan vlan-list
Mode Global Config

ipv6 dhcp snooping verify mac-address

Use this command to enable verification of the source MAC address with the client hardware
address in the received DCHP message.
Default enabled
Format
ipv6 dhcp snooping verify mac-address
Mode Global Config
M6100 Series Switches
IPv6 Commands
983