Redistribute (Ospf); Maximum-Paths (Ospf) - NETGEAR M6100 Series Reference Manual

redistribute (OSPF)

This command configures the OSPF protocol to allow redistribution of routes from the
specified source protocol or routers. The metric argument can be in the range 0–16777214.
The metric type can be 1 or 2. The tag argument can be in the range 0–4294967295.
Default metric—unspecified
type—2
tag—0
Format
redistribute {rip | bgp | static | connected} [metric metric] [metric-type {1
| 2}] [tag tag] [subnets]
Mode Router OSPF Config
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol or routers.
Format
no redistribute {rip | bgp | static | connected} [metric] [metric-type] [tag]
[subnets]
Mode Router OSPF Config

maximum-paths (OSPF)

This command sets the number of paths that OSPF can report for a given destination in
which maxpaths is platform dependent.
Default 4
Format
maximum-paths maxpaths
Mode Router OSPF Config
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back
to its default value.
Format
no maximum-paths
Mode Router OSPF Config
M6100 Series Switches
Routing Commands
718