NETGEAR M6100 Series Reference Manual page 865

The command displays the following information.
Parameter Description
IPv4 Routing Displays whether IPv4 routing is globally enabled. BGP does not include the IPv4 unicast AFI/SAFI
capability in OPEN messages it sends unless routing is globally enabled.
BGP Admin Mode Displays whether BGP is globally enabled
BGP Router ID The configured router ID
Local AS Number The router's AS number
Traps Displays whether BGP traps are enabled.
Maximum Paths The maximum number of next hops in an external BGP route.
Maximum Paths The maximum number of next hops in an internal BGP route.
iBGP
Default Keep Alive The configured keepalive time used by all peers that have not been configured with a peer-specific
Time keepalive time.
Default Hold Time The configured hold time used by all peers that have not been configured with a peer-specific hold
time.
Number of Network The number of distinct prefixes in the local RIB
Entries
Number of AS The number of AS paths in the local RIB
Paths
Default Metric The default value for the MED for redistributed routes.
Default Route Whether BGP is configured to advertise a default route. Corresponds to the
Advertise originate (BGP Router Config)
Redistributing A source of routes that BGP is configured to redistribute.
Source
Metric The metric configured with the redistribute command.
Match Value For routes redistributed from OSPF, the types of OSPF routes being redistributed.
Distribute List The name of the prefix list used to filter redistributed routes, if one is configured with the
distribute-list prefix out (BGP)
Route Map The name of the route map used to filter redistributed routes.
Neighbor The IP address of a neighbor
ASN The neighbor's ASN
MsgRcvd The number of BGP messages received from this neighbor
MsgSent The number of BGP messages sent to this neighbor
State The adjacency state. One of IDLE, CONNECT, ACTIVE, OPEN SENT, OPEN CNFRM, EST
M6100 Series Switches
command.
command.
Border Gateway Protocol Commands
865
default-information