Show Port Description - NETGEAR M6100 Series Reference Manual

Command example:
The following example shows output with an optional parameter:
(NETGEAR switch)#show port advertise 0/1
Port: 0/1
Type: Gigabit - Level
Link State: Down
Auto Negotiation: Enabled
Clock: Auto
Admin Local Link Advertisement no
Oper Local Link Advertisement
Oper Peer Advertisement
Priority Resolution
Command example:
The following example shows output without an optional parameter:
(NETGEAR switch)#show port advertise
Port Type
--------- ------------------------------ -----------
0/1 Gigabit - Level
0/2 Gigabit - Level
0/3 Gigabit - Level

show port description

This command displays the interface description. Instead of unit/slot/port, lag
lag-intf-num can be used as an alternate way to specify the LAG interface, in which
lag-intf-num is the LAG port number.
Format
show port description [unit/slot/port | lag lag-intf-num]
Mode Privileged EXEC
Term Definition
Interface unit/slot/port
ifIndex The interface index number associated with the port.
Description The alpha-numeric description of the interface created by the command
Config)
M6100 Series Switches
1000f 1000h 100f 100h 10f 10h
----- ----- ---- ---- --- ---
no yes
no no yes
no no yes
- - yes
Neg
Enabled
Enabled
Enabled
on page 325.
Switching Commands
330
no yes no
no yes no
yes yes yes
- - -
Operational Link Advertisement
------------------------------
1000f, 100f, 100h, 10f, 10h
1000f, 100f, 100h, 10f, 10h
1000f, 100f, 100h, 10f, 10h
description (Interface