Timers Bgp; Clear Ip Bgp - NETGEAR M6100 Series Reference Manual

Hide thumbs Also See for M6100 Series:
Table of Contents

Advertisement

no update-source
This command configures the peer template to use the primary IPv4 address on the outgoing
interface to the neighbor for the TCP connection.
Format
no update-source [unit/slot/port | loopback number]
Mode
Peer Template Config

timers bgp

This command configures the keepalive and hold times that BGP uses for all of its neighbors.
When BGP establishes an adjacency, the neighbors agree to use the minimum hold time
configured on either neighbor. BGP sends KEEPALIVE messages at either 1/3 of the
negotiated hold time or the configured keepalive interval, whichever is more frequent.
The new values are not applied to adjacencies already in the ESTABLISHED state. A new
keepalive or hold time is applied the next time an adjacency is formed.
Default
The default keepalive time is 30 seconds. The default hold time is 90 seconds.
Format
timers bgp keepalive holdtime
Mode
BGP Router Config
Parameter
Description
keepalive
The time, in seconds, between BGP KEEPALIVE packets sent to a neighbor. The range is 0 to
65,535 seconds. Jitter is applied to the keepalive time.
holdtime
The time, in seconds, that BGP continues to consider a neighbor to be alive without receiving a BGP
KEEPALIVE or UPDATE packet from the neighbor. If no KEEPALIVE is received from a neighbor for
longer than the hold time, BGP drops the adjacency. If the hold time is set to 0, then BGP does not
enforce a hold time and BGP does not send periodic KEEPALIVE messages. The range is 0 to
65,535 seconds.
no timers bgp
This command sets to the default the keepalive and hold times that BGP uses for all of its
neighbors.
Format
no timers bgp
Mode
BGP Router Config

clear ip bgp

This command resets peering sessions with all or a subnet of BGP peers. The command
arguments specify which peering sessions are reset and the type of reset performed. Soft
inbound reset causes BGP to send a Route Refresh request to each neighbor being reset. If
M6100 Series Switches
Border Gateway Protocol Commands
848

Advertisement

Table of Contents
loading

Table of Contents