Virtual Router Redundancy Protocol (Vrrp) Commands; Ip Vrrp; Section 14.5 "Virtual Router Redundancy Protocol (Vrrp) Commands - NETGEAR ProSafe FSM7326P Cli Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
14.5 Virtual Router Redundancy Protocol (VRRP)
Commands
This section describes the commands you use to view and configure VRRP and to view
VRRP status information. VRRP helps provide failover and load balancing when you
configure two devices as a VRRP pair.

14.5.1 ip vrrp

This command enables the VRRP protocol on an interface and designates the configured
virtual router IP address as a secondary IP address on an interface. The parameter
is the virtual router ID which has an integer value range from 1 to 255.
Default
Format
Mode
14.5.1.1 no ip vrrp
This command disables the VRRP protocol on an interface. This command also removes a
virtual router IP address as a secondary IP address on an interface. The parameter
is the virtual router ID which has an integer value ranges from 1 to 255.
Format
Mode
14.5.2 ip vrrp
This command enables the administrative mode of VRRP in the router. This command
also designates the configured virtual router IP address as a secondary IP address on an
interface.
Default
Format
Mode
14.5.2.1 no ip vrrp
This command disables the default administrative mode of VRRP in the router.
Format
Mode
Routing Commands
none
ip vrrp <vrID> <ipaddress> [secondary]
Interface Config
no ip vrrp <vrID> <ipaddress> [secondary]
Interface Config
enabled
ip vrrp <vrid> <ipaddress> [secondary]
Global Config
no ip vrrp
Global Config
v1.0, March 2006
<vrID>
<vrID>
14-25