Isdp Holdtime; Isdp Timer; Isdp Advertise-V; Isdp Enable - NETGEAR M6100 Series Reference Manual

isdp holdtime

This command configures the hold time for ISDP packets that the switch transmits. The hold
time specifies how long a receiving device should store information sent in the ISDP packet
before discarding it. The period is in the range 10–255 seconds.
Default 180 seconds
Format
isdp holdtime seconds
Mode Global Config

isdp timer

This command sets the period of time between sending new ISDP packets. The period is in
the range 5–254 seconds.
Default 60 seconds
Format
isdp timer seconds
Mode Global Config

isdp advertise-v2

This command enables the sending of ISDP version 2 packets from the device.
Default Enabled
Format
isdp advertise-v2
Mode Global Config
no isdp advertise-v2
This command disables the sending of ISDP version 2 packets from the device.
Format
no isdp advertise-v2
Mode Global Config

isdp enable

This command enables ISDP on an interface or range of interfaces.
Note: ISDP must be enabled both globally and on the interface in order for
the interface to transmit ISDP packets. If ISDP is globally disabled on
the switch, the interface will not transmit ISDP packets, regardless of
the ISDP status on the interface. To enable ISDP globally, use the
command isdp run
M6100 Series Switches
on page 570.
Switching Commands
571