Match Access-Group - Allied Telesis AT-IX5-28GPX Manual

Q S C
O OMMANDS
-
MATCH ACCESS GROUP

match access-group

Overview Use this command to define match criterion for a class-map.
Syntax
match access-group {<hw-IP-ACL>|<hw-MAC-ACL>|<hw-named-ACL>}
no match access-group
{<hw-IP-ACL>|<hw-MAC-ACL>|<hw-named-ACL>}
Mode Class Map Configuration
Usage First create an access-list that applies the appropriate permit/deny requirements.
Then use the match access-group command to apply this access-list for matching
to a class-map. Note that this command will apply the access-list matching only to
incoming data packets.
Examples To configure a class-map named cmap1 with one match criterion: access-list
3001, which allows IP traffic from any source to any destination, use the
commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-cmap)#
To configure a class-map named cmap2 with one match criterion: access-list
3001, which allows MAC traffic from any source to any destination, use the
commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-cmap)#
952 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Specify a hardware IP ACL number in the range <3000-3699>.
<hw-IP-ACL>
Specify a hardware MAC ACL number in the range <4000-4699>.
<hw-MAC-ACL>
Specify the hardware named ACL.
<hw-named-ACL>
configure terminal
access-list 3001 permit ip any any
class-map cmap1
configure terminal
access-list 4001 permit any any
class-map cmap2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
match access-group 3001
match access-group 4001
C613-50057-01 REV A