Ip Ospf Dead-Interval; Ip Ospf Hello-Interval - Dell Force10 MXL Blade Reference Manual

ip ospf dead-interval

Set the time interval since the last hello-packet was received from a router. After the interval elapses,
the neighboring routers declare the router dead.
Syntax ip ospf dead-interval seconds
To return to the default values, use the no ip ospf dead-interval command.
Parameters
seconds
Defaults
40 seconds
Command Modes INTERFACE
Command
Version 8.3.16.1
History
Usage
By default, the dead interval is four times the default hello-interval.
Information
Related

ip ospf hello-interval

Commands
ip ospf hello-interval
Specify the time interval between the hello packets sent on the interface.
Syntax ip ospf hello-interval seconds
To return to the default value, use the no ip ospf hello-interval command.
Parameters
seconds
Defaults 10 seconds
Command Modes INTERFACE
Command
Version 8.3.16.1
History
Usage
The time interval between hello packets must be the same for routers in a network.
Information
Related
ip ospf dead-interval
Commands
Enter the number of seconds for the interval.
Range: 1 to 65535. Default: 40 seconds.
Introduced on MXL 10/40GbE Switch IO Module
Sets the time interval between hello packets.
Enter a the number of second as the delay between hello packets.
Range: 1 to 65535.
Default: 10 seconds.
Introduced on MXL 10/40GbE Switch IO Module
Sets the time interval before a router is declared dead.
Open Shortest Path First (OSPFv2) | 399