Area Virtual-Link Dead-Interval; Area Virtual-Link Hello-Interval - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Default
Mode

area virtual-link dead-interval

Syntax
Default
Mode

area virtual-link hello-interval

Syntax
| OSPF Commands
428
If the authentication type is simple, the authentication key must be 8 bytes or less. If the type is
encrypt, the key may be up to 256 bytes. The
keystrokes from a Standard 101/102-key keyboard.
If the type is encrypt, a key ID in the range of 0 and 255 must be specified for
Neither the default password key nor the default key ID are configured.
Unauthenticated interfaces do not need an authentication key.
The no area virtual-link
areaid
authentication type for the OSPF virtual interface identified by areaid and neighbor.
none
Router OSPF Config
This command configures the dead interval for the OSPF virtual interface on the virtual interface
identified by and
areaid neighbor
for seconds is 1 to 65535.
The no version of this command configures the default dead interval for the OSPF virtual interface on
the virtual interface identified by areaid and neighbor. The neighbor parameter is the Router ID of
the neighbor.
area virtual-link
areaid neighbor
no area virtual-link
areaid
40
Router OSPF Config
This command configures the hello interval for the OSPF virtual interface on the virtual interface
identified by areaid and neighbor
area virtual-link
areaid neighbor
The neighbor parameter is the Router ID of the neighbor.
The 1-65535 parameter is the hello interval in seconds, specified as an integer.
Range: 1 to 65535
key is composed of standard displayable, non-control
neighbor authentication
. The parameter is the Router ID of the neighbor. The range
neighbor
dead-interval
1-65535
dead-interval
neighbor
.
hello-interval
1-65535
keyid .
command configures the default