Configuring The Vlti Peer Link - Dell PowerEdge FX2 Deployment Manual
Configuring, testing and validating vlt on a pair of fn410s i/o modules in a
poweredge fx2 chassis (v2.2)
Hide thumbs
Also See for PowerEdge FX2:
- User manual (154 pages) ,
- Owner's manual (98 pages) ,
- Configuration manual (24 pages)
Table of Contents
Advertisement
7.1.2
Configuring the VLTi peer link
In this section, the VLTi peer link is configured (Figure 31).
First, the port channel that will be assigned as the VLTi peer link is created and channel members are
assigned. Next, in Full Switch mode, a VLT domain is created. The peer link is then assigned and the
backup destination is configured to enable heartbeat communications over the management network.
Finally, a unit ID is specified to ensure that the two IOM peer switches are assigned primary or
secondary roles.
Note: In this example, the port channel number matches on both sides. This is not a strict
requirement.
FC630 Server
VLTi peer-link configuration
PowerEdge FX2 – FN I/O Module – VLT Deployment Guide | Version 2.2
35
VLT Domain
FN410S-A1
Te 0/9
Te 0/10
VLTi (Po 127)
Te 0/9
Te 0/10
FN410S-A2
VLT Domain 2
S4810-A1
S4810-A2
Hide quick links:
Advertisement
Table of Contents
