Area Nssa; Area Default-Cost - Dell Force10 MXL Blade Reference Manual

area default-cost

Set the metric for the summary default route generated by the area border router (ABR) into the stub
area. Use this command on the border routers at the edge of a stub area.
Syntax area area-id default-cost cost
To return default values, use the no area area-id default-cost command.
Parameters
area-id
cost
Defaults
cost
Command Modes ROUTER OSPF
Command
Version 8.3.16.1
History
Usage In FTOS, cost is defined with reference to bandwidth.
Information
Related
area stub
Commands

area nssa

Specify an area as a not so stubby area (NSSA).
Syntax area area-id nssa [ default-information-originate ] [ no-redistribution ] [ no-summary ]
To delete an NSSA, use the no area area-id nssa command.
Parameters
area-id
no-redistribution
default-information-ori
ginate
no-summary
Defaults
Not configured
Command Mode ROUTER OSPF
Command
Version 8.3.16.1
History
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a number from zero
(0) to 65535.
Specifies the stub area's advertised external route metric.
Range: zero (0) to 65535.
= 1; no areas are configured.
Introduced on MXL 10/40GbE Switch IO Module
Introduced on MXL 10/40GbE Switch IO Module
Creates a stub area.
Specify the OSPF area in dotted decimal format (A.B.C.D) or enter a number
from 0 and 65535.
(OPTIONAL) Specify that the
routes into the NSSA. You should only use this command in a NSSA Area
Border Router (ABR).
(OPTIONAL) Allows external routing information to be imported into the
NSSA by using Type 7 default.
(OPTIONAL) Specify that no summary LSAs should be sent into the NSSA.
redistribute command should not distribute
Open Shortest Path First (OSPFv2) | 387