Lcn Node Slot Requirements; Experion Nodes Slot Requirement; Fte Supervisory (Default); Cnet Configuration Using Pcic Interface - Dell PowerEdge R330XL Planning, Installation And Service Manual

Chapter 2 - Planning
2.4

LCN node slot requirements

NOTE
LCN support is not available for Dell PowerEdge R330XL server.
2.5

Experion nodes slot requirement

Default configurations for FTE
Broadcom on-board NICs are enabled without PXE.
l
If you are using FTE slot only, then use on-board NICs.
l

FTE supervisory (Default)

l

Cnet configuration using PCIC interface

l
2.5.1 FTE supervisory (Default)
FTE must be configured on on-board NIC.
Slot number
Slot 1
Slot 2
2.5.2 Cnet configuration using PCIC interface
The server does not support PCIC interface, you must use Magma PCIe to PCI converter box.
Slot number
Slot 1
Slot 2
2.6

Memory configuration for Dell R330XL

Standard memory for Dell PowerEdge R330XL server server is Tab 100: 8GB (2x4GB) UDIMM
2133MHz or faster and Tab 200:16GB(2x8GB) UDIMM, 2133MHz or faster, and it must be installed in
pairs The label on the outside of the shipping container shall identify the capacity of the memory
installed.
Memory Expansion Model number: Honeywell uses this number as an identity to indicate the supplier
as to what memory must be added with the platform.
Honeywell model number
MZ-PCEM36
MZ-PCEM38
Description
PCIe Slot Gen 3
PCIe Slot Gen 3
Description
PCI Slot Gen 3
PCI Slot Gen 3
Description
4GB ECC DDR4 UDIMM 2133 MHz or faster
8GB ECC DDR4 UDIMM, 2133MHz or faster
Option
Magma Host Card
-
- 14 -
Option
-
-