Single-Shot-Tunnel - Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide N to Z

single-shot-tunnel

[ no ] single-shot-tunnel
Syntax
Command introduced in JUNOSe Release 7.2.0.
Release Information
Configures the L2TP/IPSec tunnels associated with a particular L2TP host profile as
Description
single-shot tunnels. The underlying IPSec connection for a single-shot tunnel can
carry no more than a single L2TP tunnel for the duration of its existence, and the
L2TP tunnel can carry no more than a single L2TP session for the duration of its
existence. The no version restores the default behavior for L2TP/IPSec tunnels, which
disables the single-shot attribute.
NOTE: Although configuration of single-shot tunnels is more typically used with
secure L2TP/IPSec tunnels, you can also configure single-shot tunnels for nonsecure
L2TP tunnels that do not run over an IPSec transport connection.
L2TP Destination Profile Host Configuration
Mode
1172
single-shot-tunnel