Dell C9000 Series Reference Manual page 2062

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

To disable sending traps out a specific interface, use the no snmp trap-source

The IP address assigned to the management interface is the default.

Command Modes

CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information To enable this snmp-server trap-source command, configure an IP address on the

interface and enable the interface configured as an SNMP trap source.

snmp-server community

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

— sets the community string.

Simple Network Management Protocol (SNMP) and Syslog

Chapters

Table of Contents