Sflow Extended-Switch Enable - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.0)
9.7(0.0)
Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any incoming
traffic.
Related sflow enable (Global)
Commands

sflow extended-switch enable

Enable packing information on a switch only.
C9000 Series
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable]
command.
Parameters
enable
Defaults Disabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced on the C9010.
Introduced on the S6000-ON.
Introduced on the S-Series, Z-Series, and MXL switch.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow
configuration from the LAG port.
— turns sFlow globally.
Enter the keyword enable to enable global extended
information.
sFlow 2030