Snmp-Server Community - Dell C9000 Series Reference Manual

Example
Dell(conf)#snmp-server context line
Related show snmp user
Commands

snmp-server community

Configure a new community string access for SNMPv1 v2 and v3.
C9000 Series
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-access-
list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name] | security-name name [ipv6 ipv6-access-list-
name | access-list-name | security-name name] | access-list-name
[ipv6 ipv6-access-list-name | access-list-name | security-name
name]]]
To remove access to a community, use the no snmp-server community
community-string {ro | rw} [security-name name [access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name]]
command.
Parameters
community-name
ro
rw
ipv6 access-list-
name
security-name
name
access-list-name
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
— displays the information configured on each SNMP user name.
Enter a text string (up to 20 characters long) to act as a
password for SNMP.
Enter the keyword ro to specify read-only permission.
Enter the keyword rw to specify read-write permission.
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a
string up to 16 characters long).
(Optional) Enter the keywords security-name then the
security name as defined by the community MIB.
(Optional) Enter a standard IPv4 access list name (a string up to
16 characters long).
Simple Network Management Protocol (SNMP) and Syslog 2049