6.5.3
Operating Procedure
Use the following procedure to enable waiting for slave detection.
1.
Start the MPE720 on a computer that is connected to the MP3000.
In the Main Window of the MPE720, click Setup − Module configuration from the
2.
Launcher, or Module Configuration from the Start Menu.
The Module Configuration Definition Tab Page will be displayed.
3.
Double-click the SVC4 cell in the Module Configuration Definition Tab Page.
The MECHATROLINK Detail Definition Dialog Box will be displayed.
4.
Click the Transmission Parameters Tab.
The Transmission Parameters Tab Page will be displayed.
6.5 Waiting for Slave Detection with the SVC Function Module
6.5.3 Operating Procedure
6-15
6