Table of Contents
Advertisement
Module Configuration Definition Tab Page Details
The following table describes the items that are displayed in the Module Configuration Defini-
tion Tab Page.
No.
Item
Module
Function Module/Slave
Status
Start
Circuit No./
Axis
Occu-
Address
pied cir-
cuits
Motion Register
Disabled
Start -
End
Register
(Input/Out-
put)
Size
Scan
Display/Setting Item
Displays the Module that is set for
the slot.
Displays the Function Modules and
slaves that are used by the Mod-
ule.
In Online Mode, displays the status
of the Function Modules and the
communications status of MECHA-
TROLINK slave devices.
Displays the first circuit number
that is assigned to the Function
Module.
Displays the number of circuits that
are assigned to the Function Mod-
ule.
Displays the first and last register
addresses of the motion parame-
ters.
Used to disable inputs or outputs
by selecting the check boxes.
Displays the range of registers that
is used as an I/O area by the Func-
tion Module. For the SVC or
SVC32, the first and last registers
of the I/O Modules that are con-
nected to MECHATROLINK are
displayed.
Displays the number of words in
the I/O area.
Displays the scan in which the I/O
service is performed for the I/O
device.
7.1 Module Configuration Settings
7.1.1 Settings for Motion Control Function Modules
Setting Range/Settings
Any Module
Any Function Module or
slave
Refer to the following
section.
Status Display
Contents on page
7-4
Circuit No. 1 to 16
1 or 2
The parameter is auto-
matically set based on the
circuit numbers.
Selected or not selected
Start: 0000 to 7FFF hex
End: 10000 to 17FFFF
hex, 800 hex words max.
1 to 1024
High/Low
Continued on next page.
Changing
Possible
Possible
Not possible
Possible
Possible
Not possible
Possible
7
Possible
*
Possible
Possible
7-3
Advertisement
Table of Contents
