Table of Contents
Advertisement
When the local station is set as a slave station, the address specified on the Transmission
Parameters Tab Page is displayed.
• Setting range: 03 hex to EF hex
ExADR
Set the individual extended addresses when multi-station modules (multi-slaves) are grouped
together as a single node.
This box is displayed when the Display Expansionist Address Button is clicked, and is hidden
when the Omit Expansionist Address Button is clicked.
• Setting range: 03 hex to EF hex
• Setting the Extended Address
Extended addresses are set in succession from extended address 00 hex.
The following figure shows an example of how to set extended addresses.
Set the extended address in
order starting from 00 hex: 01
hex, 02 hex, etc.
VENDOR
Set the vendor name of the device.
• Selections: Yaskawa Electric co.,∗∗∗∗Vendor
DEVICE
Set the slave model.
• Link Assignment Model Details
The relationship between the model displayed under DEVICE and its corresponding profile is
shown below.
If you manually assign a link, be sure that the actual device connected to the SVC Function
Module is the same as the one that is displayed under DEVICE on the Link Assignment Tab
Page.
DEVICE
SGD7S-
20
SGD7W-
20
SGDV-
2
1000Series INVERTER
JAPMC-MC2320-E
SVC32
JEPMC-MTD2310-E
JEPMC-MTA2900-E
JEPMC-MTA2910-E
JEPMC-MTP2900-E
7.2.2 MECHATROLINK Detail Definition Dialog Box Details
Communications Specifications
Number of Trans-
Supported Profiles
mission Bytes
Standard Servo
32, 48
Standard Inverter
32, 64
Standard I/O
16, 32, 48, 64
Standard I/O
16, 32, 48, 64
Standard I/O
Standard I/O
Standard I/O
Standard I/O
7.2 MECHATROLINK Communications Settings
Minimum Trans-
mission Cycle
125 μs
250 μs
250 μs
125 μs
250 μs
16
125 μs
32
125 μs
16
125 μs
64
Continued on next page.
Maximum Trans-
mission Cycle
4 ms
7
8 ms
32 ms
32 ms
8 ms
8 ms
8 ms
8 ms
7-11
Advertisement
Table of Contents
